Therefore, during the reading process, there is an extra CNF1, Boot outputs low level and CNF1 outputs high level. For TPROT8-10,the Bosch Company set the anti-debugging mode, reading EEPROM needs no password and reading Flash needs password. Grounding, then follow the Ktag user manual to wire the cable and read the data.ĥ. The Infineon ECU before TPROT8 is not encrypted, you directly uses the BOOT point There are 3 types of Bosch Infineon ECU :ģ) The Infineon ECU after TPROT10 which is what we call GPT encrypted.Ĥ. Advise you use Open Port2.0 as the protocol conversion equipment and work with PC.ģ. The switch board is designed to work with J2534, this device uses the Ktag cables so the user can refer to the Ktag wiring diagram.Ģ. How to Use KTM FlASH ECU Programmer Switch Board?ġ. KTMflash ECU Programmer & Transmission Power Upgrade Tool Below share how to use KTM FlASH ECU programmer switch board. KTMflash ECU Programmer & Transmission Power Upgrade Tool read and write ECU data, read transmission data etc at a high speed. KTMflash Transmission Power Upgrade Tool support ECU programming function. KTMflash ECU Programmer Read the BOOT mode according to the chip model. KTM FlASH ECU Programmer User Guide To Switch Board
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |